Audio-Technica AT2020 Microphone
Audio-Technica AT2020 Microphone

20/20 Hearing

For a high quality microphone ready to pair with almost any interface, gear up with the Audio-Technica AT2020 Condenser Microphone. A great all-around mic for beginners and veterans alike, the AT2020 is built with a low-mass diaphragm for extended frequency response and excellent transient response. Thanks to the cardioid polar pattern, peripheral noises are reduced and you get focused isolation on the sound source of your choice, not the overall room.

Note: This drop comes with a free 10' Pig Hog XLR Cable.

Audio-Technica AT2020 Microphone

Keep It Close

When used with vocals, the AT2020 brings enough warmth to flatter any voice and enough air to avoid sibilance. Thanks to the low noise, you can close-mik instruments or vocals without worry. Finished off with strong rear-axis rejection and a particularly fruitful partnership with acoustic guitars, the Audio-Technica AT2020 Condenser Microphone makes recording a breeze no matter what sound you’re trying to capture.

Audio-Technica AT2020 MicrophoneAudio-Technica AT2020 Microphone

Specs

  • Audio-Technica
  • Custom-engineered low-mass diaphragm
  • Cardioid polar pattern
  • Pivoting, threaded stand mount
  • Fixed-charge back plate
  • Permanently polarized condenser
  • Integral 3-pin XLRM-type output connector
  • Frequency response: 20 - 20,000 Hz
  • Open circuit sensitivity: -37 dB (14.1 mV) re 1 V at 1 PA
  • Impedance: 100 Ohms
  • Maximum input sound level: 144 dB SPL, 1 kHz @ 1% THD
  • Noise: 20 dB SPL
  • Dynamic range: 124 dB, 1 kHz @ max SPL
  • Signal to noise ratio: 74 dB, 1 kHz @ 1 Pa
  • Phantom power requirements: 48 V DC, 2 mA typical
  • 6.38 x 2.05 in (162 x 52 mm)
  • 12.1 oz (345 g)

Included

  • Stand mount for 5/8”-27 threaded stands
  • 5/8”-27 to 3/8”-16 threaded adapter
  • Soft protective pouch
  • 10' Pig Hog XLR Cable

Shipping

All orders will be shipped by Massdrop.

Estimated ship date is Dec 16, 2014 PT.

After the drop ends, payment will be collected. To deliver the best value to the group the request will then be submitted to the vendor up front, making all sales final. Be sure to check the discussion page for updates.