It's a good, solid case, with an alright finish. Doesn't come without it's issues though. The hole for the USB port wasn't cut very well, and there are no wood stand offs as shown on alot of the pictures on the description page. The screw inserts lay flat with the case, which causes issues if you have things that stick out on your PCB. My Pok3r RGB (dual PCB) wobbled quite a bit because of this, and another PCB with holtites had some issues too. The inserts were also misaligned.
It's a shame because I love the case, but for some users it's going to require some modding.
Same deal with my Pok3r RGB... I had to file out a bit near the dip switch hole and file out a bit around where the USB port would sit. Once that was done it fit pretty well. Except the left side screw hole didn't match my PCB. 5/6 screws is enough for me. Went with thicker nonslip pads instead of the tiny ones it came with, in case of wobble.
You are currently viewing a single conversation. Return to Full Discussion