Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone

Interchangeable-Capsule Condenser Mic

Ideal for a range of studio products, including the overhead miking of drum kits, the Superlux S241/U3 is a true capacitor condenser microphone with a half-inch gold-evaporated diaphragm. Along with interchangeable capsule modules and an FET preamplifier, it boasts a slight high-end elevation in frequency response that makes it ideal for capturing signals rich in transients—like those of acoustic guitars, snare drums, and hi-hats. The switchable attenuator (with 0, -10, and -20 dB settings) allows for use in extreme level applications up to 143 dB SPL, while the switchable low-cut filter (with flat, 75 Hz, and 150 Hz settings) minimizes room rumble and unwanted low-frequency pickup.

Note: This drop is limited to 75 units.

Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone
Superlux S241/U3 Condenser Microphone

Specs

  • Superlux
  • Type: Condenser microphone
  • Element: Pressure gradient, FET preamplifier
  • Diaphragm: 0.5 in (1.3 cm) gold-evaporated
  • Polar pattern: Cardioid
  • Finish: Gray
  • External sensitivity attenuation pad: 0, -10, and -20 dB
  • External low-cut filter switches: Flat, 75 Hz, and 150 Hz
  • Frequency response: 20 Hz – 20 kHz
  • Sensitivity: -35 dBV/Pa (17.8 mV/Pa)
  • Rated impedance: 200 ohm
  • Minimum loaded impedance: 1 kohm
  • Equivalent noise level: 16 dB
  • Signal-to-noise ratio: 78 dB
  • Maximum SPL: 143 dB (THD ≤ 1% 1 kHz)
  • Dynamic range: 112 dB
  • Power supply: 48 V +/- 4 V phantom power
  • Current drain: 3 mA
  • Output connector: Integral 3-pin XLR male type
  • Dimensions: 0.9 x 6.1 in (2 x 15 cm)
  • Weight: 7.8 oz (220 g)

Included

  • Microphone clip
  • Foam windscreen
  • Micro-perf metal pop filter
  • Elastic shock mount
  • Hardshell plastic carrying case

Shipping

All orders will be shipped by Massdrop.

Estimated ship date is May 16, 2017 PT.

After the drop ends, payment will be collected. To deliver the best value to the group the request will then be submitted to the vendor up front, making all sales final. Be sure to check the discussion page for updates.