Bought one for my phantom, doesn't have enough clearance, Was thinking of maybe trying to make an acrylic spacer for it but idk. The switch plate from Mech keyboards i have on my phantom is also loose in this case :C. Otherwise very solid and nice, even game with a usb breakout board for the port.
yanfaliThere is clearance room in the case, but it's opposite from the side the teensy is mounted, i was thinking of desoldering the teensy (I already had a plate/pcb/switches soldered which made figuring out what to do a little harder) and then hand wiring some wires to the teensy pads and just having the teensy sit where there would be enough clearance. As for the loose plate i noticed there were some holes where the phantom pcb and plate had consistent with the top frame of the case, so if i had some 2.5m screws i could screw the switch plate against the bottom of the top case effectively holding it there. However when i was desoldering i accidently knocked an smd capacitor or fuse from my teensy @.@ so i haven't tried the hand wiring approach. I did go ahead and start designing a poorly routed tkl pcb to fit both this lambo case and phantom plate from mechanicalkeyboards but it needs some finalizing and a prototype run to double check x3